Toro 31974, Руководство оператора, Страница: 10 / 28

g296783
Figure 7
1. Jam nuts 3. Height-of-cut chain
2. U-bolt
7. Adjust the nuts ( Figure 7 ) to raise or lower the
rear of the cutting unit so that the tips of the rear
blades are 6 to 10 mm (1/4 to 3/8 inch) higher
than the front tips.
8. Tighten the jam nuts.
6
Greasing the Cutting Unit
No Parts Required
Procedure
Before operating the cutting unit, it must be greased
to ensure proper lubricating characteristics; refer
to
Greasing the Bearings and Bushings (page 16) .
Failure to properly grease the machine will result in
premature failure of critical parts.
Product Overview
Specifications
Note:
Specifications and design are subject to
change without notice.
Width of
Cut
•
Model No. 31974: 1.52 m (60 inches)
•
Model No. 31975: 1.82 m (72 inches)
Height of
Cut Adjustable from 25 to 152 mm (1 to 6 inches) in 13
mm (1/2 inch) increments
Net
Weight
•
Model No. 31974: 195 kg (430 lb)
•
Model No. 31975: 222 kg (490 lb)
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to
www.Toro.com for a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
10