Toro 31698, Руководство оператора, Страница: 89 / 100

Cutting Unit Maintenance
Pivoting (Tilting) the Front
Cutting-Unit to the Upright
Position
Note:
Although not needed for normal maintenance
procedures, you can pivot (tilt) the front cutting unit to
an upright position.
1. Raise the front cutting unit slightly off the floor,
engage the parking brake, shut off the engine,
and remove the key.
2. Perform the pre-maintenance procedure; refer
to
Pre-Maintenance Procedures (page 63) .
3. Remove the retainer clip and disconnect the
damper assembly from the cutting unit (
Figure
133 ).
g008980
Figure 133
1. Damper assembly 2. Retainer clip
4. Remove the hairpin cotter and clevis pin
securing the height-of-cut chains to the rear of
the cutting unit (
Figure 134 ).
g008979
Figure 134
1. Height-of-cut chain 3. Hairpin cotter
2. Clevis pin
5. Start the engine, slowly raise the front cutting
unit, shut off the engine, and remove the ignition
key.
6. Wedge a block of wood between the rear of the
deck and the machine (
Figure 135 ).
g008985
Figure 135
1. Block of wood
89