Toro 316000001, Руководство по установке

Страница: 7 / 12

3. Remove the 2 mounting pegs from the drain valve (A
of
Figure 12 ).
Figure 12
1. Mounting peg 3. Flange-head bolts (5/16 x
1 inch)
2. Drain valve 4. Flange locknuts (5/16
inch)
4. Thread the 2 flange locknuts (5/16 inch) onto the 2
flange-head bolts (5/16 x 1 inch) as shown in (B and
C of
Figure 12 )
5. Assemble the flange locknuts and flange-head bolts to
the drain valve and tighten them by hand (D and E of
Figure 12 ).
6. Align the locknuts of the drain valve with the holes
of the keyhole slots in the drain-valve bracket (A of
Figure 13 ).
Figure 13
7. Move the drain valve outboard and down to secure the
valve to the bracket (B and C of
Figure 13 ).
8
Checking the Clearance of the
Boom Covers
No Parts Required
Procedure
Verify that the outer-boom covers do not bind against the
center-boom cover when you raise and lower the booms.
Note:
Install shims between the outer-boom covers and
the truss frame of the outer-boom section to add clearance
between the covers as needed; refer to
Figure 14 .
7