Toro 31529, Руководство по установке

Страница: 7 / 20

3
Installing the Coils on
the Flow-Divider Manifold
Assembly
4WD Switch Only
Parts needed for this procedure:
1 Plug
2 Valve
2 Coil (12 V)
2 Coil nut
Procedure
Important:
The manifold comes pre-assembled
for use without the switch; this procedure is
necessary if you are going to install the 4WD
switch.
1. Remove the 2 existing valves from the CV1 and
CV2 ports of the manifold.
2. Install the appropriate parts to the flow-divider
manifold as shown in
Figure 7 .
g230515
Figure 7
1. Coil nut 4. Existing orifice (removed)
2. Coil (12 V) 5. Plug
3. Valve 6. New orifice
3. Torque the coil nuts to 6.8 to 9.5 N∙m (5 to 7
ft-lb).
4. Torque the valves to 34 N∙m (25 ft-lb).
5. Install the plug over the new orifice.
Note:
You may discard the removed orifice and
valves.
7