Toro 31526, Руководство по установке

Страница: 4 / 20

2
Removing the Hydraulic
Lines
No Parts Required
Removing the Hydraulic Hoses
1. Align a drain pan below the forward end of the
hydraulic-pressure hose (
Figure 2 ).
g212935
Figure 2
1. Rear traction manifold 5. Rear traction hose
2. Traction-control hose 6. Traction motor
3. Hydraulic pump 7. Divider tube
4. Hydraulic-pressure hose 8. Combination manifold
2. Remove the forward fitting of the
hydraulic-pressure hose from the middle
fitting of the divider tube, and allow the hydraulic
fluid to drain from the hose and tube (
Figure 3 ).
g212936
Figure 3
1. Bulkhead fitting 4. Rear fitting (divider tube)
2. Rear fitting (rear traction
hose) 5. Middle fitting (divider tube)
3. Forward fitting (rear
traction hose) 6. Forward fitting (pressure
hose)
3. Temporarily plug the hydraulic-pressure hose.
4. Remove the forward fitting of the rear traction
hose from the rear fitting of the divider tube
(
Figure 3 ).
5. Remove the rear fitting of the rear traction hose
from the bulkhead fitting in the bulkhead near
the steering axle (
Figure 3 ).
4