Toro 315000001, Руководство оператора

Страница: 10 / 32

Figure 14
1. Left tank bracket (slotted
flange angled down from
right to left) 3. Carriage bolt (3/8 x 1 inch)
2. Flanged locknut (3/8 inch)
5. Align the left tank bracket onto the carriage bolt (3/8
x 1 inch) at the upper-inboard holes of the left, front
strap (
Figure 14 ).
Note:
Ensure that the tank bracket is aligned with the
pocket molded into the top rear part of the rinse tank.
Note:
Replace the R-clamp during this time too.
6. Secure the tank bracket to the carriage bolt and strap
(
Figure 14 ) with a flanged locknut (3/8 inch).
7. Align the hose mount, spacer (3/8 x 1/4 inch), and
right tank bracket onto the carriage bolt (3/8 x 1
inch)at the upper-inboard hole of the right-front strap.
(
Figure 15 ).
Note:
Ensure that the tank bracket is aligned with the
pocket molded into the top rear part of the rinse tank.
Figure 15
1. Flanged locknut (3/8 inch) 4. Right tank bracket (slotted
flange angled down from
left to right)
2. Hose mount 5. Carriage bolt (3/8 x 1-1/4
inch)
3. Spacer (3/8 x 1/4 inch)
8. Secure the hose mount, spacer, and tank bracket to
the carriage bolt and strap (
Figure 15 ) with a flanged
locknut (3/8 inch).
Note:
Once the rinse tank has been initially filled with water,
check the rinse-tank bracket fasteners and tightened the nuts
as needed because the weight of the liquid in the tank can
further seat the tank against the frame.
Installing the Fresh Water Tank
1. Align the holes in the fresh water tank with the slots in
the mounting bracket; refer to
Figure 3 in Removing
the Fresh Water Tank (page 6) .
2. Assemble the tank to the bracket with the 4
flanged-head bolts that you removed in step
2 of
Removing the Fresh Water Tank (page 6) .
3. Torque the bolts to 1017 to 1355 N-cm (90 to 120
in-lb).
10