Toro 31213, Руководство пользователя

Страница: 2 / 16

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
1
No parts required
–
Prepare the machine.
2
Double pulley assembly 1 Install the pulley assembly.
3
No parts required
–
Remove the existing anti-scalp roller
and bracket (for 60-inch decks only).
Blower hinge 1
Metal template 1
Bolt (3/8 x 1 inch) 3 or 4
4
Locknut (3/8 inch)
3 or 4
Install the blower hinge.
Blower belt 1
5
Spring 1
Route the blower belt into the blower
assembly.
6
Blower assembly 1 Install the blower assembly.
Belt cover 1
Bolt (1/2 x 2-1/2 inches) 1
7
Nut (1/2 inch) 1
Install the belt cover and bolt.
Front guard 1
Back guard 1
Bolt (1/4 x 5/8 inch) 6
8
Nut (1/4 inch) 1
Install the blower guards.
Latch bracket assembly 1
Bolt (3/8 x 2-1/2 inches) 2
Nut (3/8 inch) 2
Latch bracket strap 1
Screw (#10 x 1/2 inch) 2
9
Nut (#10) 2
Install the tube latch.
Belt cover bracket 1
Carriage bolt (1/4 x 3/4 inch) 2
10
Locknut (1/4 inch) 2
Install the new belt cover bracket upon
removal of the kit (for model 31212
only).
11
Throttle stop 1 Install the throttle stop.
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Preparing the Machine
No Parts Required
Procedure
Perform the following procedure to prepare the mower
for attaching the blower and finishing kit.
1. Park the machine on a level surface, disengage
the PTO, move the motion-control levers to the
N
EUTRAL
-
LOCK
position, and engage the parking
brake.
2. Turn the key switch to the O
FF
position, remove
the key, and wait for all movement to stop before
leaving the operating position.
3. Repair all bent or damaged areas on the mower
deck and replace any missing parts.
4. Clean any debris off the deck or rear part of the
mower to ease installation.
2