Note:
Determine the left and right sides of the machine
from the normal operating position.
Important:
The fasteners on the covers of this
machine are designed to remain on the cover after
removal. Loosen all of the fasteners on each cover a
few turns so that the cover is loose but still attached,
then go back and loosen them until the cover
comes free. This will prevent you from accidentally
stripping the bolts free of the retainers.
DANGER
Do not start the engine and engage the PTO when
PTO shaft is not connected to blower shaft because
the PTO shaft will rotate with enough force to cause
serious injury.
Note:
The traction unit must be equipped the
Attachment Frame Kit, Toro Part No. 110–8540 before
the Debris Blower Mounting Kit can be installed. The
Attachment Frame Kit can be obtained from your Toro
Distributor.
Note:
If the traction unit was purchased without a
cutting unit, the following parts must be purchased
separately. The parts can be obtained from your Toro
Distributor.
Description
Part Number
Qty
Lift arm
117–0806
1
Lift arm
117–0800
1
Clevis pin
107–7904
2
Hair pin cotter
3290–256
2
Thrust washer
107–7915
4
Pivot pin assembly
98–2330
2
Cotter pin
3272–24
2
HOC collar
110–0641
2
Clevis pin
107–3457
2
Hair pin cotter
3290–467
2
1
Mounting the Arms to the
Attachment Frame
Parts needed for this procedure:
2
Arm
1
Stop
4
Bolts (7/16 x 3 inches)
6
Locknut (7/16 inch)
12
Washer
2
Bolt (7/16 x 3-1/4 inches)
Procedure
1. Position the machine on a clean, level surface. Lower
any implement, stop the engine, apply the parking
brake and remove the key from the ignition switch.
2. Loosely install the left arm to the attachment frame
using 3 bolts (7/16 x 3 inches), 3 locknuts (7/16
inch), and 6 washers (Figure 2).
Figure 2
1.
Left arm
2.
Attachment frame
3. Loosely install the right arm and the stop to the
attachment frame using 1 bolt (7/16 x 3 inches),
2 bolts (7/16 x 3-1/4 inches—installed through
the stop), 3 locknuts (7/16 inch), and 6 washers
(Figure 3).
7
