Toro 30799, Руководство оператора, Страница: 11 / 24

11
3
2
1
Figure 11
1. Lift bracket
2. Square U–bolt
3. U–bolt
2
1
Figure 12
1. Lift bracket 2. Castor arm
2. Hook H.O.C. chain onto remaining U-bolt.
3. Thread a hex nut onto each end of U-bolt.
4. Loosely mount U-bolt and H.O.C. chain to rear lift
bracket 2 nuts and 2 flange nuts
5. Mount height-of-cut chain to 2 in. height-of-cut hole
with clevis pin and hairpin cotter.
6. Position rear castors in 2 in. height-of-cut.
7. Adjust nuts on U-bolt until rear of deck is parallel to
floor (Distance from floor to bottom rear edge of all
three deck chambers must be equal).
Install Drive Shaft To Traction
Unit
Note: To ease installation of PTO shaft, remove right
traction tire.
1. Slide smaller yoke end of drive shaft onto traction unit
PTO shaft while aligning mounting holes. Secure with
roll pin.
1
Figure 13
1. Drive shaft
Install Lift Chains
1. Connect lift chains to lift arm and cutting unit chain
brackets with (6) shackles, (3/8 x 1-1/2 in.) shackle pins
and (1/8 x 3/4 in.) cotter pins. To ensure that cutting
unit lifts properly, secure chains to the following links
when connecting:
•
Front Left – 8th link
•
Front Right – 8th link
•
Rear – 14th link (All links)
2. Check operation to ensure that all chains lift deck tight
against stops when lift arm is raised.
2
3
1
Figure 14
1. Front left lift chain
2. Front right lift chain
3. Rear lift chain