Toro 30484, Руководство оператора

Страница: 50 / 60

Figure 73
40 inch, 48 inch, and 52 inch Mower Deck shown
1. Measure blade at points A
and B
2. Measure from a level
surface
Figure 74
36 inch Mower Deck shown
Changing the Mower Deck
Front-to-Rear Pitch
Changing the front-to-rear pitch is done by adjusting the
front height-of-cut posts.
1. To change the front-to-rear pitch, the front
height-of-cut posts can be adjusted (Figure 75).
Figure 75
1. Caster Wheel 4. Jam nut
2. Carrier Frame
5. Ball joint
3. Front height-of-cut pins
2. To raise the front of the deck, loosen jam nut and
rotate the front pin clockwise (Figure 75).
3. To lower the front of the deck, loosen jam nut and
rotate the front pin counter clockwise (Figure 75).
4. Position the blades front-to-rear. Measure at C and
D locations (Figure 73) from a level surface to the
cutting edge of the blades.
5. Check the side-to-side leveling of the cutting unit.
6. Tighten the jam nuts (Figure 75).
Checking the Mower Deck
Side-to-Side Height
1. Adjust the rear tire pressure to specifications; refer
to Drive System Maintenance (page 33) .
2. Position the blades side-to-side. Measure at C and
D locations from a level surface to the cutting edge
of blade tips (Figure 76). For 36 inch mower decks
use Figure 77.
50