Toro 30484, Руководство оператора

Страница: 51 / 60

Figure 76
40 inch, 48 inch, and 52 inch Mower Deck shown
1. Measure from a level
surface 2. Measure blade at points C
and D
Figure 77
36 inch Mower Deck shown
3. The difference between measurements C and D
should be no more than 1/4 inch (6 mm).
Changing the Mower Deck
Side-to-Side Height
Changing the side-to-side height is done by adjusting the
rear tire pressure and caster spacers.
1. Change the rear tire pressure. Do this to the
corresponding side that needs adjustment.
2. Adjust the caster spacer.
3. Recheck the front-to-rear pitch and side to side
leveling of the cutting unit.
Matching Height of Cut
1. Check the rear tire pressure.
2. Set the height-of-cut to the 4 inch (101.6 mm)
position following the height-of-cut decal.
3. With the machine on level surface, position one blade
front-to-rear. Measure at A and from level surface to
the cutting edge of the blade tips (Figure 78). For 36
inch mower decks use Figure 79.
Figure 78
40 inch, 48 inch, and 52 inch Mower Deck shown
1. Measure from a level
surface 2. Measure blade at point A
Figure 79
36 inch Mower Deck shown
4. The measurement should be 4 inch (101.6 mm).
5. If it does not measure correctly:
A. Adjust the rear tire pressure.
B. Adjust the caster fork spacers.
C. Adjust the front mower deck support pins.
6. Check the carrier frame front-to-rear pitch.
51