Toro 30447, Руководство оператора

Страница: 25 / 76

2. Remove the tensioning cap from the spindle shaft
(Figure 20) and slide the spindle out of castor arm.
Put the two shims (1/8 inch [3 mm]) onto spindle
shaft as they were originally installed. These shims
are required to achieve a level across the entire width
of the cutting units. Slide the appropriate number
of 1/2 inch spacers onto the spindle shaft to get the
desired height-of-cut; then slide the washer onto
the shaft.
Figure 20
1. Tensioning cap 4. Top axle mounting hole
2. Spacers 5. Castor wheel
3. Shims
Refer to the following chart to determine the
combinations of spacers for the setting.
Figure 21
3. Push the castor spindle through the castor arm.
Install the shims (as originally installed) and the
remaining spacers onto the spindle shaft. Install the
tensioning cap to secure the assembly.
4. Remove the hairpin cotter and clevis pins from the
castor pivot arms (Figure 22).
5. Rotate tension rod to raise or lower pivot arm until
holes are aligned with selected height-of-cut bracket
holes in the cutting unit frame (Figure 22 and
Figure 23).
6. Insert the clevis pins and install the hairpin cotters.
7. Rotate tension rod counterclockwise (finger tight)
to put tension on adjustment.
Figure 22
1. Castor pivot arm 3. Clevis pin and hair pin
cotter
2. Axle mounting holes 4. Tension rod
Figure 23
Adjusting the Skids
The skids should be mounted in the lower position
when operating in height of cuts greater than 2-1/2
inches (64 mm) and in the higher position when
operating in height of cuts lower than 2-1/2 inches (64
mm).
Adjust the skids by removing the flange bolt and nuts,
positioning them as desired, and installing the fasteners
(Figure 24).
25