Toro 30403, Руководство оператора

Страница: 10 / 28

7. Install the height of cut collars onto the height
of cut rods and secure with the clevis pins and
hairpin cotters (
Figure 5 ). Position the head of
the clevis pin toward the front of the deck, if
possible.
8. Install a bolt (1/2 x 3/4 inch) and a washer to top
of each height of cut rod (
Figure 5 ).
6
Connecting the PTO Shaft
to the Cutting Unit Gearbox
No Parts Required
Procedure
1. Slide the male PTO shaft into the female PTO
shaft (
Figure 6 ). Align the mounting holes in the
gear case input shaft with the holes in the PTO
shaft and slide them together.
g012230
Figure 6
1. PTO shaft 3. Gear case
2. Bolts and locknuts 4. Roll pin
2. Secure them with a roll pin ( Figure 6 ).
3. Tighten the bolts and nuts ( Figure 6 ).
7
Greasing the Machine
No Parts Required
Procedure
Before operating the machine, it must be greased to
ensure proper lubricating characteristics; refer to
7
Greasing the Machine (page 10) . Failure to properly
grease the machine will result in premature failure of
critical parts.
10