Toro 30320, Руководство оператора

Страница: 26 / 48

26
Servicing the Air Cleaner
Service Interval and Specification
Foam Element: Clean and re-oil after every 25 operating
hours.
Paper Element: Clean after every 50 operating hours.
Replace after every 200 operating hours.
Note: Service the air cleaner more frequently (every few
hours) if operating conditions are extremely dusty or
sandy.
Removing the Foam and Paper Elements
1. Disengage the power take off (PTO), chock or block
tires, and turn the ignition key to off. Remove the key.
2. Clean around the air cleaner to prevent dirt from
getting into the engine and causing damage. Pull out
on retaining latches and remove the air cleaner cover
(Fig. 25).
3. Unscrew nut and remove the air cleaner assembly
(Fig. 25).
4. Carefully pull the foam element off the paper element
(Fig. 25).
ÔÔÔÔÔ
ÔÔÔÔÔ
ÔÔÔÔÔ
ÔÔÔÔÔ
ÔÔÔÔÔ
ÔÔÔÔÔ
m–4689
5
1
2
3
4
Figure 25
1. Retaining latch
2. Cover
3. Nut
4. Foam element
5. Paper element
Cleaning the Foam Element
1. Wash the foam element in liquid soap and warm water.
When the element is clean, rinse it thoroughly.
2. Dry the element by squeezing it in a clean cloth.
3. Put one or two ounces of oil on the element (Fig. 26).
Squeeze the element to distribute the oil.
Important
Replace the foam element if it is torn or
worn.
ÔÔÔÔÔÔÔ
ÔÔÔÔÔÔÔ
ÔÔÔÔÔÔÔ
ÔÔÔÔÔÔÔ
ÔÔÔÔÔÔÔ
ÔÔÔÔÔÔÔ
ÔÔÔÔÔÔÔ
2
m–4694
1
Figure 26
1. Foam element 2. Oil
Cleaning the Paper Element
1. Lightly tap the element on a flat surface to remove
dust and dirt (Fig. 27).
2. Inspect the element for tears, an oily film, and damage
to the rubber seal.
Important
Never clean the paper element with
pressurized air or liquids, such as solvent, gas, or
kerosene. Replace the paper element if it is damaged,
defective, or cannot be cleaned thoroughly.
1
m–4695
2
Figure 27
1. Paper element 2. Rubber seal
Installing the Foam and Paper Elements
Important To prevent engine damage, always operate
the engine with the complete foam and paper air cleaner
assembly installed.
1. Carefully place the foam element onto the paper air
cleaner element (Fig. 25).
2. Place the air cleaner assembly onto the air cleaner base
(Fig. 25). Secure with nut.