Toro 30318, Руководство оператора

Страница: 39 / 56

1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3. Remove the knobs/rubber washers holding
the carrier frame cover and remove the carrier
frame cover.
4. Remove the knobs/rubber washers holding
the belt covers to the top of the cutting unit
and remove the belt covers.
5. Remove the heat shield from the engine deck
and carrier frame.
6. Remove the idler spring from idler arm.
Remove the drive belt from the PTO clutch
pulley, idler pulleys and the left spindle pulley
(Figure 52).
7. Install the new drive belt onto the PTO
engagement pulley and the top groove of the
center spindle pulley (Figure 52).
8. Install the belt onto idler pulleys and then
install idler spring (Figure 52).
9. Install the heat shield to the engine deck and
carrier frame.
10. Adjust the belt guide an 1/8 inch (3 mm) from
the belt (Figure 52).
11. Install the belt covers onto the cutting unit,
then reinstall and tighten the knobs/rubber
washers.
12. Install the carrier frame cover onto the
cutting unit, then reinstall and tighten the
knobs/rubber washers.
Figure 52
1. PTO engagement pulley 4. Center spindle pulley
2. PTO drive belt idler pulley 5. PTO drive belt guide
3. PTO drive Belt 6. Idler spring
Mower Deck
Maintenance
Servicing the Cutting Blades
To ensure a superior quality of cut, keep the
blades sharp. For convenient sharpening and
replacement, you may want to keep extra blades
on hand.
A worn or damaged blade can break, and a
piece of the blade could be thrown into the
operator’s or bystander’s area, resulting in
serious personal injury or death.
• Inspect the blade periodically for wear
or damage.
• Replace a worn or damaged blade.
Before Inspecting or Servicing the
Blades
Park the machine on a level surface, disengage
the blade control bail and set the parking brake.
Turn the ignition key to off. Remove the key and
disconnect the spark plug wire(s) from the spark
plug(s).
39