Toro 30318, Руководство оператора

Страница: 25 / 56

Figure 23
1. Carrier Frame 4. Spacers
2. Hairpin Cotter 5. Back height-of-cut post
3. Front height-of-cut post
Adjusting the Gage Wheels
The gage wheels need to be adjusted in the proper
hole location for each height-of-cut position.
There needs to be 3/8 inch (10 mm) minimum
clearance above the ground.
1. After adjusting height-of-cut, check the gage
wheels so that there is a minimum of 3/8 inch
(10 mm) clearance above the ground (Figure 24
and Figure 25).
2. If adjustment is needed, remove the bolt,
washers and nut (Figure 24 and Figure 25).
3. Select a hole position so the gage wheels are a
minimum of 3/8 inch (10 mm) off the ground
(Figure 24 and Figure 25).
4. Install the bolt, washers and nut (Figure 24 and
Figure 25).
Figure 24
1. Gage Wheels 4. Washer
2. Nut 5. Spacer
3. Bolt
Figure 25
1. Center Gage Wheels and
spacer
3. Bolt
2. Nut 4. Washer
Adjusting the Handle Height
The handle position can be adjusted to match the
operator’s height preference.
1. Remove hairpin cotter, washer and clevis pin
securing control rod fitting to idler bracket
(Figure 26).
25