![Toro 30069 Скачать руководство пользователя страница 25](http://html1.mh-extra.com/html/toro/30069/30069_operators-manual_1133119025.webp)
After the first 8 hours
Every 100 hours
Every 200 hours—Change the oil
filter.
Note:
Change the oil more frequently when the
operating conditions are extremely dusty or sandy.
Oil Type: Detergent oil (API service SF, SG, SH, or SJ)
Crankcase Capacity: 58 ounces (1.7 liter) with the filter
removed; 51 ounces (1.5 liter) without the filter removed
Viscosity: Refer to the table (Figure 22).
Figure 22
Checking the Engine Oil Level
1. Park the machine on a level surface.
2. Disengage the PTO and set the parking brake.
3. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
4. Clean around the oil dipstick (Figure 23) so that dirt
cannot fall into the filler hole and damage the engine.
Figure 23
1.
Oil dipstick
2.
Filler tube
5. Unscrew the oil dipstick and wipe the end clean
6. Slide the oil dipstick fully into the filler tube, but do
not thread onto tube (Figure 23).
7. Pull the dipstick out and look at the end. If the oil
level is low, slowly pour only enough oil into the filler
tube to raise the level to the Full mark.
Important:
Do not overfill the crankcase with
oil and run the engine; engine damage can
result.
Changing the Oil
1. Start the engine and let it run five minutes. This
warms the oil so it drains better.
2. Park the machine so that the drain side is slightly
lower than the opposite side to assure the oil drains
completely.
3. Disengage the PTO and set the parking brake.
4. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
5. Slide the drain hose over the oil drain valve.
6. Place a pan below the drain hose. Rotate oil drain
valve to allow oil to drain (Figure 24).
7. When oil has drained completely, close the drain
valve.
8. Remove the drain hose (Figure 24).
Note:
Dispose of the used oil at a recycling center.
Figure 24
1.
Oil drain valve
2.
Oil drain hose
9. Slowly pour approximately 80% of the specified oil
into the filler tube (Figure 23).
25
Содержание 30069
Страница 47: ...Schematics G0161 12 Electrical Schematic Rev A Hydraulic Schematic Rev A 47...
Страница 48: ...Notes 48...
Страница 49: ...Notes 49...
Страница 50: ...Notes 50...