Toro 30069, Руководство оператора

Страница: 10 / 52

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
1
No parts required
–
Check the fluids and tyre pressure.
Operator's Manual 1
Engine Operator's Manual 1
Parts Catalog 1
Operator training material 1
Registration Card 1
2
Oil drain hose 1
Read the Operator's Manual and watch
the operator training material before
operating the machine.
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Checking the Fluids and Tyre
Pressure
No Parts Required
Procedure
• Before you start the engine and use the machine,
check the oil level in the engine crankcase; refer to
Checking the Engine Oil Level.
• Check the grease for the mower and mower deck.
• Check the tyre pressure; refer to Checking the tyre
Pressure.
Note:
The cutting blades are set to a 2 inch (51mm)
height-of-cut at initial purchase. The Axle position is
B , with 2 spaces below the casters and 4 spaces below
the spindle.
2
Reading the Manual and
Viewing the Operator Training
Material
Parts needed for this procedure:
1 Operator's Manual
1 Engine Operator's Manual
1 Parts Catalog
1 Operator training material
1 Registration Card
1 Oil drain hose
Procedure
• Read the Operator's Manual .
• View the operator training material before operating
the machine. The DVD supplied is general training
material and the machine may differ from that
supplied.
• Fill out the registration card.
• Use the oil drain hose when changing the engine oil.
10