Toro 29639, Руководство оператора

Страница: 6 / 20

Figure 6
3. Wipe off the dipstick end with a clean cloth.
4. Insert the dipstick into the oil-fill tube, but do not
screw it in.
5. Remove the dipstick and read the oil level on the
dipstick (Figure 7).
•
If the oil level is too low, slowly pour a small
amount of oil into the oil-fill tube, wait 3 minutes,
and then repeat steps 3 through 5 until the oil level
is correct.
•
If the oil level is too high, drain the excess oil until
the oil level is correct. To drain the excess oil, refer
to Changing the Engine Oil (page 13).
Important:
If the oil level in the crankcase is
too low or too high and you run the engine,
you may damage the engine.
Figure 7
1. Oil level is too low 3. Oil level is correct
2. Oil level is too high
6. Install the dipstick into the oil-fill tube securely.
Important:
Change the engine oil after the first 5
operating hours ; change it yearly thereafter; refer
to Changing the Engine Oil (page 13).
Product Overview
Figure 8
1. Spark plug 6. Grass bag
2. Oil fill/dipstick (not shown) 7. Fuel-tank cap
3. Recoil-start handle 8. Cutting-height levers (4)
4. Blade-control bar 9. Air filter
5. Self-propel drive bar
Figure 9
1. Rear-discharge deflector (optional attachment; Toro part
89964)
Specifications
Model Weight Length Width Height
29639 34 kg
(75 lb)
144 cm
(57 inches)
54 cm
(21 inches)
145 cm
(39 inches)
6