Toro 29639, Руководство оператора

Страница: 5 / 20

Setup
1
Installing the Handle
No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Loosen the handle knobs (Figure 3).
Important:
Route the cables to the outside of the
handle as you install the handle.
Figure 3
1. Handle knob (2)
2. Move the handle to the operating position (Figure 4).
Figure 4
3. Tighten the handle knobs firmly by hand (Figure 3).
2
Installing the Recoil-starter
Rope in the Rope Guide
No Parts Required
Procedure
Important:
You must install the recoil-starter rope in
the rope guide.
Hold the blade-control bar to the upper handle and pull the
recoil-starter rope through the rope guide on the handle
(Figure 5).
Figure 5
1. Recoil-starter rope 2. Rope guide
3
Filling the Engine with Oil
No Parts Required
Procedure
Important:
This machine does not come with oil in the
engine. Before starting the engine, fill the engine with
oil.
1. Move the machine to a level surface.
2. Remove the dipstick (Figure 6) and pour about 3/4 of
the crankcase capacity of oil into the oil-fill tube.
Note:
Max. fill: 0.59 L (20 oz), type: SAE 30 or SAE
10W-30 detergent oil with an API service classification
of SF, SG, SH, SJ, SL, or higher.
5