Toro 22983, Руководство оператора

Страница: 23 / 52

Pre-Maintenance
Procedures
Removing the Cover Plate
Note:
The fasteners on the covers of this machine
are designed to remain on the cover after removal.
Loosen all fasteners on each cover a few turns so that
the cover is loose but still attached, then go back and
loosen them until the cover comes free. This prevents
you from accidentally stripping the bolts free of the
retainers.
1. Park the machine on a level surface, engage
the parking brake (if applicable), and lower the
boom.
2. Shut off the engine and remove the key.
WARNING
There is a rotating shaft under the cover
that is moving when the machine is
running and can catch fingers, hands,
loose hair, and clothing, causing serious
injury, amputation, or death.
Always shut off the engine and wait for
all moving parts to stop before removing
the cover.
3. Loosen the bolt at the rear of the cover plate.
4. Loosen the 3 bolts securing the cover plate to
the frame sequentially until the cover is loose
(
Figure 19 ).
g258957
Figure 19
1. Bolt (3) 2. Cover plate
5. Slide the cover plate toward the right side of the
machine, then pull it off over the bolts and off
the machine.
6. To install the cover plate before operating the
machine, slide the plate into place and secure it
with the 3 bolts you loosened previously (
Figure
19 ).
Lubrication
Greasing the Machine
Service Interval: Before each use or daily (Grease
immediately after every washing.)
Grease Type: General-purpose grease.
1. Park the machine on a level surface, engage the
parking brake, and lower the boom.
2. Shut off the engine and remove the key.
3. Clean the grease fittings with a rag.
4. Connect a grease gun to each fitting ( Figure 20
through Figure 22 ).
5. Pump grease into the fittings until grease begins
to ooze out of the bearings (approximately 3
pumps).
6. Wipe up any excess grease.
g007821
Figure 20
g007822
Figure 21
23