Toro 22445, Руководство оператора

Страница: 8 / 16

Maintenance
Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first 5 hours
• Lubricate the drive chain.
• Adjust the drive chain tension.
Before each use or daily
• Check the tines (replace as required).
• Check and tighten the tine bolts (replace as required).
• Check the hydraulic lines for leaks, loose fittings, kinked lines, loose mounting
supports, wear, weather, and chemical deterioration.
Every 25 hours
• Grease the shaft bearing (immediately after every washing).
• Lubricate the drive chain.
• Adjust the drive chain tension.
Before storage
• Grease the shaft bearing
• Lubricate the drive chain.
• Adjust the drive chain tension.
• Lubricate the shaft bearing.
• Paint chipped surfaces.
CAUTION
If you leave the key in the switch, someone could accidently start the engine and seriously
injure you or other bystanders.
Remove the key from the switch before you perform any maintenance.
Greasing the Tiller
Service Interval: Every 25 hours—Grease the shaft
bearing (immediately after every
washing).
Before storage—Grease the shaft bearing
Grease Type: General-purpose grease
1. Park the machine on a level surface and
disengage the auxiliary hydraulics.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings with a rag.
g327246
Figure 4
4. Connect a grease gun to each fitting.
5. Pump grease into the fittings until grease begins
to ooze out of the bearings.
6. Wipe up any excess grease.
8