Lubrication
Greasing the Traction Unit
Service Interval:
Before each use or daily (Grease
immediately after every washing.)
Grease Type: General-purpose grease.
1. Lower the loader arms and stop the engine. Remove
the key.
2. Clean the grease fittings with a rag.
3. Connect a grease gun to each fitting (Figure 32 and
Figure 32
Figure 33
4. Pump grease into the fittings until grease begins to
ooze out of the bearings (approximately 3 pumps).
5. Wipe up any excess grease.
Engine Maintenance
Servicing the Air Cleaner
Service Interval:
Every 25 hours—Clean the foam air
filter element and check the paper
element for damage.
Every 100 hours—Replace the paper
air filter element.
Note:
Service the air cleaner more frequently if
operating conditions are extremely dusty or sandy.
Removing the Filters
1. Lower the loader arms, stop the engine, and remove
the key.
2. Open the hood.
3. Clean around the air cleaner to prevent dirt from
getting into the engine and causing damage.
4. Unscrew the knob and remove the air cleaner cover
(Figure 34).
Figure 34
1.
Knob
6.
Foam pre-filter
2.
Air cleaner cover
7.
Paper filter
3.
Cover nut
8.
Rubber seal
4.
Spacer
9.
Air cleaner base
5.
Cover
5. Carefully slide the foam pre-filter off of the paper
element (Figure 34).
6. Unscrew the cover nut and remove the cover, spacer
and paper filter (Figure 34).
29
Содержание 22331 TX 420
