Toro 22189TE, Руководство оператора

Страница: 23 / 32

8. Move the lower anchor bracket up one hole
(Figure 27).
9. Repeat steps 1 through 3 to adjust the control bar.
Note:
When you install a new belt, move the lower
anchor bracket to its original factory position, which
is indicated by the notches next to the holes in the
bracket (Figure 27).
Controls System
Maintenance
Adjusting the Blade Brake
Cable
Whenever you install a new blade brake cable assembly
or replace the belt, adjust the blade brake cable.
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the wire from the spark plug (Figure 11).
3. Remove the fuel tank from the tank bracket.
Note:
You do not need to disconnect the fuel line
from the fuel tank.
4. Reset the cable adjuster on the handle so that 1/4
inch (6 mm) of the threads show, then tighten the
nut (Figure 28).
Figure 28
1. Adjuster 3. 1/4 inch (6 mm) of threads
2. Nut
5. Loosen the cable clamp screw until the brake cable
conduit slides (Figure 29).
23