Toro 21765, Руководство оператора

Страница: 8 / 24

Product Overview
g272915
Figure 7
1. Handle 9. Cutting-height lever (4)
2. Self-propel bar 10. Spark plug
3. Blade-control bar 11. Side-discharge deflector
4. Adjustment for the
self-propel drive 12. Oil-fill tube/dipstick
5. Rear deflector (not shown) 13. Bag-on-demand lever
6. Washout port (not shown) 14. Handle lock (2)
7. Fuel-tank cap 15. Recoil-start handle
8. Air filter
g036586
Figure 8
1. Grass bag 2. Side-discharge chute
Specifications
Model Weight Length Width Height
35 kg 152 cm 58 cm 104 cm
21765
(77 lb) (60
inches)
(23
inches)
(41
inches)
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com for a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.
Before Operation
Before Operation Safety
General Safety
•
Always shut off the machine, wait for all moving
parts to stop, and allow the machine to cool before
adjusting, servicing, cleaning, or storing it.
•
Become familiar with the safe operation of the
equipment, operator controls, and safety signs.
•
Check that all guards and safety devices, such as
deflectors and/or grass catcher, are in place and
functioning properly.
•
Always inspect the machine to ensure that the
blades and blade bolts are not worn or damaged.
•
Inspect the area where you will use the machine,
and remove all objects that could interfere with
the operation of the machine or that the machine
could throw.
•
Contact with the moving blade will cause serious
injury. Do not put your fingers under the housing
when adjusting the cutting height.
8