•
Be aware of a potential fire hazard in very dry
conditions, follow all local fire warnings, and keep
the mower free of dry grass and leaf debris.
•
Alternate the mowing direction. This helps disperse
the clippings over the lawn for even fertilization.
•
If the finished lawn appearance is unsatisfactory, try
one or more of the following:
– Replace the blade or have it sharpened.
– Walk at a slower pace while mowing.
– Raise the cutting height on your mower.
– Cut the grass more frequently.
– Overlap cutting swaths instead of cutting a full
swath with each pass.
– Set the cutting height on the front wheels one
notch lower than the rear wheels. For example,
set the front wheels at 2 inches (51 mm) and the
rear wheels at 2-3/8 inches (60 mm).
Cutting Leaves
•
After cutting the lawn, ensure that half of the lawn
shows through the cut leaf cover. You may need to
make more than one pass over the leaves.
•
If there are more than 5 inches (13 cm) of leaves
on the lawn, set the front cutting height one or two
notches higher than the rear cutting height.
•
Slow down your mowing speed if the mower does
not cut the leaves finely enough.
Maintenance
Note:
Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first 5 hours
• Change the engine oil.
Before each use or daily
• Check the engine oil level.
• Ensure that the engine stops within 3 seconds after releasing the blade control bar.
• Check the blade brake clutch operation.
• Clean grass clippings and dirt from under the mower.
Every 25 hours
• Replace the air filter; replace it more frequently in dusty operating conditions.
• Clean the blade brake clutch shield.
Before storage
• Empty the fuel tank before repairs as directed and before annual storage.
Yearly
• Change the engine oil.
• Lubricate the wheel gears.
• Replace the blade or have it sharpened (more frequently if the edge dulls quickly).
• Refer to your Engine Operator’s Manual for any additional yearly maintenance
procedures.
Important:
Refer to your
Engine Operator’s Manual
for additional maintenance procedures.
14
