Toro 20093, Руководство оператора

Страница: 18 / 24

6. Remove the blade brake clutch shield (Figure 45).
7. Brush or blow out debris from the inside of the
shield and around all the parts.
8. Install the blade brake clutch shield that you
previously removed.
9. Install the blade driver that you previously removed.
10. Install the blade and the stiffener that you previously
removed (Figure 45).
11. Install the blade nuts and torque them to 15 to
27 ft-lb (20 to 37 N
⋅⋅⋅
m).
Cleaning the Mower
Service Interval: Before each use or daily
The mower may dislodge material from under
the mower housing.
• Wear eye protection.
• Stay in the operating position (behind the
handle) when the engine is running.
• Do not allow bystanders in the area.
For best results, clean the mower soon after you have
completed mowing.
1. Lower the mower to its lowest cutting height setting.
Refer to Adjusting the Cutting Height.
2. Move the mower onto a flat paved surface.
3. Attach a garden hose that is connected to a water
supply to the washout port on the mower housing
(Figure 46).
Figure 46
1. Washout port
4. Turn the water on.
5. Start the engine and run it until there are no more
clippings that come out from under the mower
housing.
6. Stop the engine.
7. Shut off the water and disconnect the garden hose
from the mower.
8. Start the engine and run it for a few minutes to dry
the housing.
18