Toro 20090, Руководство оператора

Страница: 12 / 20

Preparing for Maintenance
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the spark plug wire from the spark plug
(Figure 25) before performing any maintenance
procedure.
Figure 25
3. After performing the maintenance procedure(s),
connect the spark plug wire to the spark plug.
Important:
Before tipping the mower to change
the oil or replace the blade, allow the fuel tank
to run dry through normal usage. If you must
tip the mower prior to running out of fuel, use a
hand fuel pump to remove the fuel. Always tip
the mower onto its side with the air filter up.
Tipping the mower may cause the fuel to leak.
Gasoline is flammable, explosive and can cause
personal injury.
Run the engine dry or remove the gasoline with
a hand pump; never siphon.
Replacing the Air Filter
Service Interval: Yearly
1. Perform the pre-maintenance procedures; refer to
Preparing for Maintenance.
2. Use a screw driver to open the air filter cover
(Figure 26).
Figure 26
3. Replace the air filter.
4. Install the cover (Figure 27).
Figure 27
Changing the Engine Oil
Service Interval: After the first 5 hours
Every 50 hours
Run the engine a few minutes before changing the oil
to warm it. Warm oil flows better and carries more
contaminants.
1. Perform the pre-maintenance procedures; refer to
Preparing for Maintenance.
2. Remove the dipstick (Figure 28).
Figure 28
3. Tip the mower onto its side, with the air filter up,
to drain the used oil out through the oil fill tube
(Figure 29).
Figure 29
12