
Figure 26
3. Tip the mower onto its side with the air filter up
to drain the used oil out through the oil fill tube
(Figure 27).
Figure 27
4.
Slowly
pour oil into the oil fill tube until the oil level
reaches the
Full
line on the dipstick (Figure 26).
Do
not overfill.
(Max. fill: 20 oz. (0.59 l), type: SAE
30W detergent oil with an API service classification
of SF, SG, SH, SJ, SL, or higher.)
5. Install the dipstick securely.
6. Dispose of the used oil properly at a local recycling
center.
Charging the Battery
Service Interval:
Every 25 hours
Electric-start models only
Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
Charge the battery for 24 hours initially, then monthly
(every 25 starts) or as needed. Always use the charger
in a sheltered area and charge the battery at room
temperature (70° or 22° C) whenever possible.
1. Connect the charger to the mower wire harness
located below the ignition key (Figure 28).
Figure 28
2. Plug the charger into a wall outlet.
Note:
When the battery no longer holds a charge,
recycle or dispose of the lead-acid battery according
to local codes.
Replacing the Fuse
Electric-start models only
If the battery does not charge or the engine does not run
with the electric starter, the fuse may be blown. Replace
it with a 40-amp plug-in type fuse. Refer to Installing
the Fuse.
16
Содержание 20066
Страница 42: ...Notas 22 ...
Страница 43: ...Notas 23 ...