Toro 136-0372, Руководство по установке

Страница: 22 / 64

Figure 44
1. Brown wire (cutting the
conductor) 3. Taping the end of the
brown wire and blue wire
2. Blue wire (cutting the
conductor) 4. Taping wires together
B. Wrap the end of the brown wire with electrical
tape to seal the wire (
Figure 44 ).
C. Wrap the end of the blue wire with electrical tape
to seal the wire (
Figure 44 ).
D. Fold the brown wire and blue wire to the yellow
and green wire and wrap the 3 wires together with
the electrical tape (
Figure 44 ).
Installing the Master-Spray Valve
Connector
1. Insert the yellow and green wire of the DIN wire
harness into the butt-splice connector on the white
wire of the 3-pin adapter for the master-spray valve
(
Figure 45 ).
Figure 45
1. 4-pin adapter (rate valve) 4. White wire (3-pin
adapter—master-spray
valve)
2. 3-pin adapter (agitation
valve) 5. Yellow and green
wire (DIN wire
harness—master-spray
valve)
3. 3-pin adapter
(master-spray valve)
2. Center the crimping tool over the butt-splice connector
and wires and crimp the connector securely.
3. Align the black wire of the 4-pin adapter for the rate
valve and the black wire of the 3-pin adapter of the
agitation valve, and the blue wire of the DIN wire
harness with the black wire of the 3-pin adapter for
the master-spray valve; refer to the wire table for the
master-spray valve (
Figure 46 ).
22