Toro 120-7122, Руководство по установке, Страница: 3 / 8

2
Installing the Bagger Frame
Parts needed for this procedure:
1 Bagger frame (discard frame in bagger kit)
1
Bagger frame support bracket (discard bracket in
bagger kit)
2
Self tapping screw (5/16 x 3/4 inch) (included in
bagger kit)
4 Hair pin cotter — Included in Bagger Kit 79326
2 Rod — Included in Bagger Kit 79326
4 Washer — Included in Bagger Kit 79326
2
Bolt (5/16 x 2-1/2 inch) — Included in Bagger Kit
79326
2
Lock nut (5/16 inch) — Included in Bagger Kit 79326
1
Clevis pin (1/2 x 2-1/4 inch) — Included in Bagger
Kit 79326
1 Spacer plate — Included in Bagger Kit 79326
1 Angled plate — Included in Bagger Kit 79326
Procedure
1. Locate the bagger frame bracket. Install the bracket
to the machine frame as shown in Figure 3. Secure
the bracket to the frame using two bolts (5/16 x
2-1/2 inch) and two lock nuts (5/16 inch).
G016262
Figure 3
1. Machine frame 4. Bolt (5/16 x 2-1/2 inch)
2. Support spacer plate 5. Lock nut (5/16 inch)
3. Support bracket
2. Secure the support bracket to the bottom of the
machine frame from below using two self tapping
screws (5/16 x 3/4 inch) as shown in Figure 4.
G016263
Figure 4
1. Support bracket 2. Self tapping screws (5/16
x 3/4 inch)
3. Remove the existing fasteners securing the
rectangular spacer plate from the top of the engine
frame and remove the plate.
4. Install the new angle spacer plate as shown in
Figure 4 using the fasteners removed previously.
5. Install the bagger frame to the support bracket.
Secure the bagger frame with a clevis pin (1/2 x
2-1/4 inch) and hair pin cotter (Figure 5).
G016264
Figure 5
1. Bagger frame 5. Clevis pin (1/2 x 2-1/4
inch)
2. Spacer plate, rectangular
(existing) 6. Spacer plate, angle (new)
3. Hair pin 7. Fasteners, existing
4. Support bracket
6. Install two support rods, one to each side of the
bagger frame. Locate the existing bracket between
the rear drive wheel and frame (Figure 6).
3