Toro 117-0354, Руководство по установке, Страница: 6 / 8

5
Installing the Foot Pedal
(Machines with 48, 52 and 60
inch Mower Decks)
Parts needed for this procedure:
1 Foot pedal
Procedure
1. Remove the existing foot pedal from the machine. Save
the existing hardware.
2. Install the new foot pedal onto the machine using the
existing hardware ().
g018228
1
2
3
Figure 7
1. Existing bolts 3. Existing nuts
2. New foot pedal
Operation
Using the Z Stand®
The Z Stand® raises the front end of the machine to allow
you to clean the mower and remove the blades.
WARNING
The machine could fall onto someone and cause
serious injury or death.
• Use extreme caution when operating the
machine on the Z Stand®.
• Use only for cleaning the mower and removing
the blades.
• Do not keep the machine on the Z Stand for
extended periods of time.
• Always turn the engine off, set the parking
brake, and remove the key before performing
any maintenance to the mower.
Driving up onto the Z Stand
Important:
Use the Z Stand on a level surface.
1. Raise the mower to the transport position.
2. Remove the bracket pin (Figure 8).
Figure 8
1. Z Stand 4. Bottom of slot
2. Bracket Pin 5. Latch
3. Bracket
3. Raise the latch. Swing the stand foot out front and
slide stand toward machine, into the bottom of slot
(Figure 8 and Figure 9).
4. Lengthen the Z Stand by removing the clevis pin and
hairpin cotter pin from the outer tube and sliding the
foot out.
6