Toro 09960, Руководство оператора, Страница: 29 / 92

g339547
Figure 35
1. Bump-stop switch
3. Reset the bump-stop switch; refer to Resetting
the Bump-Stop Switch (page 46) .
Testing the Coring Head-Reverse
Interlock
1. Perform 1 of the following:
•
Move the machine to a turf area where you
can aerate without damaging the tines or the
area.
•
Remove the tines.
2. Hold either operator-presence bail to the
handlebar, rotate the top of the traction control
forward, and close the aerate bail (
Figure 36 ).
Note:
The machine drives forward, coring head
runs, and it lowers.
g339546
Figure 36
1. Operator-presence bail 3. Traction control
2. Aerate bail
3. While holding the operator-presence bail and
aerate bail, rotate the top of the traction control
backward (
Figure 37 ).
Important:
The coring head must raise and
stop running.
Note:
The engine remains running.
g339549
Figure 37
1. Traction control
4. Move the traction control to the N
EUTRAL
position.
5. If you removed the tines, install them and
calibrate the tine ground height; refer to
Assembling the Tines to the Coring Head (page
30)
and Calibrating the Tine Ground Height
(page 36) .
Installing Turf Guards, Tine
Holders, and Tines
Important:
You must calibrate tine ground height
each time you change from longer tines to shorter
tines or from shorter tines to longer tines.
A wide selection of tine holders, turf guards, and tines
are available for the machine. Choose the required
components per the accessory chart in Attachments
and Accessories.
Preparing the Machine
1. Raise the coring head and lock it in position with
the service latch; refer to
Supporting the Coring
Head with the Service Latch (page 50) .
2. Park the machine on a level surface, fully raise
and latch the handlebar to engage the parking
brake, shut off the engine, remove the key, and
wait for all moving parts to stop.
Assembling the Turf Guards
Note:
The factory ships turf guard clamps, washers,
and flange locknuts secured to the turf guard brackets
(
Figure 38 ).
Loosely assemble the turf guards to the turf guard
brackets with 4 turf-guard clamps and 12 flange
locknuts (3/8 inch) and 12 washers (7/16 x 13/16 inch).
29