1
All Rights Reserved
Printed in the USA
W
2008 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Discharge Chute Kit
For Sand Pro, Grounds Pro and Groundsmaster Debris
Blowers
Model No. 08860
Form No. 3324–993 Rev. A
Installation Instructions
Note:
If front discharge is desired, an optional Chute,
Toro Part No. 104–0329–01, is available.
1.
Remove screws and washers securing deflector to
blower discharge opening (Fig. 1). Remove deflector
and retain for future installation.
Sand Pro Debris Blower Shown
1
2
Figure 1
1. Discharge opening
deflector
2. Deflector mounting screws
2.
Mount pivot assembly to top of chute assembly with
(5) 3/8116 x 7/8” lg. carriage bolts, .406 x .813 flat
washers and 3/8–16 locknuts (Fig. 2).
Note:
Chute assembly can be rotated 180 degrees for right
or left discharge on debris blower.
1
2
Figure 2
1. Pivot assembly
2. Chute assembly
3.
Using (2) 3/8–16 x 7/8” carriage bolts, .406 x .813 flat
washers and 3/8–16 locknuts, mount a cover plate and
spring mount bracket to slot in front of blower
discharge chute (Fig. 3).
4.
Using (2) 3/8–16 x 7/8” carriage bolts, .406 x .813 flat
washers and 3/8–16 locknuts, mount a cover plate to
slot in rear of blower discharge chute (Fig. 3).
1
2
Back
1
Front
Figure 3
1. Cover plate
2. Spring mount bracket
5.
Mount a eye bolt to side of chute assembly with (2)
washers and jam nuts. Position eye bolt as shown in
(Fig. 4).
1
Figure 4
1. Eye bolt
6.
Mount the deflector to chute assembly with screws and
washers previously removed (Fig. 5).
