Toro 08839, Руководство оператора

Страница: 28 / 64

Selecting the Multi-Tool
1. Fully lift the multi-tool carrier; refer to Raising the
Mid-Mount Attachment (page 26) .
2. Rotate the multi-tool carrier backward until you
can fully access the clevis pin and the 13 mm
(1/2 inch) hole in the angle-select plate; refer
to
Tilting the Mid-Mount Attachment Forward
(page 27) .
g365930
Figure 35
1. Clevis pin and hole (angle-select plate)
3. Remove the hairpin and clevis pin that secures
the multi-tool arm to the angle-select plate
(
Figure 36 ).
g359129
Figure 36
1. Multi-tool arm 3. Hairpin
2. Hole (angle-select plate) 4. Clevis pin
4. Repeat step 3 at the other side of the machine.
CAUTION
The multi-tool arm rotates freely when
the clevis pins are removed; your hands
or fingers could get pinched and injured
if they are caught between the multi-tool
arm and the angle-select plate.
• Keep your hands and fingers clear of
the area behind the angle-select plate
while rotating the multi-tool.
• Secure multi-tool arm from movement
before removing the second clevis
pin.
5. Rotate the multi-tool arm to select a set of plow
tines (
Figure 37 ).
g359130
Figure 37
6. Align the hole in the multi-tool arm with the hole
in the angle-select plate (
Figure 38 ).
g359128
Figure 38
1. Hole (angle-select plate) 3. Clevis pin
2. Multi-tool arm 4. Hairpin
7. Secure the multi-tool arm to the angle-select
plate with the clevis pin and hair pin.
8. Repeat step 7 at the other side of the machine.
28