Toro 08712, Руководство оператора

Страница: 10 / 24

g028340
Figure 16
Important:
Ensure that the existing hoses
are routed above the guide, as shown in
Figure 16 .
8
Installing the Hydraulic
Cylinder
Parts needed for this procedure:
1 45° hydraulic fitting with O-ring
1 Hydraulic cylinder
1 90° hydraulic fitting with O-ring
1 Small retaining ring
1 Pin
2 Large retaining ring
Procedure
1. Thread a 90° fitting into the upper port in the
hydraulic cylinder. Position the fitting as shown
in
Figure 17 .
Note:
Make sure that all O-rings are lubricated
and properly positioned on fittings before
installation.
Note:
To prevent contamination to the hydraulic
fittings or hoses, do not remove the caps from
the fittings or hoses until they are installed.
2. Thread a 45° fitting into the lower port in the
hydraulic cylinder. Position the fitting as shown
in
Figure 17 .
g003669
Figure 17
1. Hydraulic cylinder 3. 45° fitting
2. 90° fitting 4. Plug (1/8 inch)
3. Mount the top of the hydraulic cylinder barrel
to the pin on the right-hand plow plate with a
retaining ring (
Figure 18 ).
Note:
Position the cylinder hydraulic ports
forward.
g028342
Figure 18
1. Retaining ring 4. Push arm strap
2. Hydraulic cylinder 5. Pin
3. Pin (on plow plate)
4. Mount the cylinder rod to the push arm straps
with a pin and 2 retaining rings (
Figure 18 ).
10