Toro 07385TC Workman HDX-D, Оригинальное руководство пользователя

Страница: 57 / 64

11. Shut off the engine and attachment and check
for leaks.
Changing the Hydraulic
Fluid and Cleaning the
Strainer
Service Interval: Every 800 hours
Hydraulic-fluid capacity: 7 L (7.5 US qt)
Hydraulic-fluid type: Dexron III ATF
1. Park the machine on a level surface, engage the
parking brake, shut off the engine, and remove
the key.
2. Remove the drain plug from the side of the
reservoir, and let the hydraulic fluid flow into a
drain pan (
Figure 66 ).
g009623
Figure 66
1. Hydraulic reservoir 2. Drain plug
3. Note the orientation of the hydraulic hose and
90° fitting connected to the strainer on the side
of the reservoir (
Figure 67 ).
4. Remove the hydraulic hose and 90° fitting.
5. Remove the strainer and clean it by back
flushing it with a clean de-greaser.
Note:
Allow it to air dry before installing.
g002416
Figure 67
1. Hydraulic strainer
6. Install the strainer.
7. Install the hydraulic hose and 90° fitting to the
strainer in the same orientation.
8. Install and tighten the drain plug.
9. Fill the reservoir with approximately 7 L (7.5
US qt) of the specified hydraulic fluid; refer to
Checking the Transaxle/Hydraulic-Fluid Level
(page 55)
.
10. Start the engine and operate the machine to fill
the hydraulic system.
11. Check the hydraulic-fluid level and replenish it,
if required.
Important:
Use only the hydraulic fluid specified.
Other fluids could damage the system.
Replacing the Hydraulic
Filter
Service Interval: After the first 10 hours
Every 800 hours
Important:
Use of any other filter may void the
warranty on some components.
1. Park the machine on a level surface, engage the
parking brake, shut off the engine, and remove
the key.
2. Clean the area around the filter-mounting area.
3. Place a drain pan under the filter and remove
the filter (
Figure 68 ).
57