Toro 07362TC, Руководство оператора

Страница: 18 / 60

7
Full Bed Removal
No Parts Required
Procedure
1. Start engine. Engage hydraulic lift lever and lower
bed until cylinders are loose in slots. Release lift lever
and turn off engine.
2. Remove lynch pins from outer ends of cylinder rod
clevis pins (Figure 11).
Figure 11
1. Bed mounting plate 4. Lynch pin
2. Cylinder rod end 5. Rear slots (Full bed)
3. Clevis pin 6. Front slots (2/3 bed)
3. Remove clevis pins securing cylinder rod ends to
bed mounting plates by pushing pins towards inside
(Figure 12).
4. Remove lynch pins and clevis pins securing pivot
brackets to frame channels (Figure 12).
5. Lift bed off vehicle.
The full bed weighs approximately 325 pounds,
so do not try to install or remove it by yourself.
Use an overhead hoist or get the help of two or
three other people.
6. Store cylinders in storage clips. Engage hydraulic lift
lock lever on vehicle to prevent accidental extension
of lift cylinders.
8
Re-Install the Full Bed
No Parts Required
Procedure
Note:
If bed sides will be installed on flat bed, it is
easier to install them before bed is installed on vehicle.
Note:
Assure rear pivot plates are bolted to the bed
frame/channel so that lower end angles to the rear
(Figure 12).
Figure 12
1. Left rear corner of bed 4. Clevis pin
2. Vehicle frame channel 5. Lynch pin
3. Pivot plate
Note:
Make sure spacer brackets and wear blocks
(Figure 13) are installed or radiator cover may be
damaged. Carriage bolts heads to be positioned inside
the machine.
18