Form No. 3385-461 Rev A
Door Kit with Sliding Window
Workman
®
MDX or HDX Utility Vehicle
Model No. 07356
Model No. 07393
Installation Instructions
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals known to the State of California to
cause cancer, birth defects, or reproductive harm.
Installation
1
Preparing to Install the Door
Kit
No Parts Required
Procedure
1.
Move the machine to a level surface and set the parking
brake.
2.
Shut off the engine, set the parking brake, and remove
the key from the ignition switch.
2
Installing the Doors
Parts needed for this procedure:
1
Right-hand door
1
Left-hand door
2
Ball stud
2
Locknut (5/16 inch)
2
Door strut
4
Washer
Procedure
1.
Insert the ball stud through the rear hole in the bracket
on the cab frame, and install the locknut (5/16 inch)
onto the ball stud (Figure 1).
Figure 1
1.
Locknut (5/16 inch)
3.
Frame
2.
Bracket
4.
Ball stud
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3385-461* A
