Toro 07266TC, Руководство оператора

Страница: 37 / 44

Belt Maintenance
Servicing the Drive Belt
Checking the Drive Belt
Service Interval: After the first 8 hours
Every 200 hours
Check the condition and tension of the drive belt after
the first day of operation and every 200 operating hours
thereafter.
1. Park the machine on a level surface, shift into
Neutral, set the parking brake, turn the ignition off,
and remove the key.
2. Raise the bed and secure it with the prop rod.
3. Rotate and inspect the belt (Figure 45) for excessive
wear or damage. Replace the belt if necessary.
G01 1948
1
2
3
Figure 45
1. Drive belt 3. Secondary clutch
2. Primary clutch
Replacing the Drive Belt
1. Rotate and route the belt over the secondary clutch
(Figure 45).
2. Remove the belt from the primary clutch (Figure 45).
3. To replace the belt, reverse the procedure.
Adjusting the Starter
Generator Belt
Service Interval: After the first 8 hours
Every 200 hours
1. Park the machine on a level surface, set the parking
brake, turn the ignition off, and remove the key.
2. Loosen the starter generator pivot nut (Figure 46).
Figure 46
1. Primary drive clutch
housing 4. Starter generator belt
2. Drive belts 5. Generator pivot bracket
3. Starter generator 6. Generator pivot nut
3. Wedge a pry bar between the engine mount and
starter..
4. Tilt the starter in the slot until the belt flexes 1/4 inch
(6 mm) with 10 lb (44 N) of force (Figure 46).
5. Tighten the starter generator nut and remove the
pry bar (Figure 46). Torque the nut to 65-85 ft-lb
(88-115 N-m).
37