Toro 07266TC, Руководство оператора

Страница: 21 / 44

Maintenance
Note:
Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first 8 hours
• Change the engine oil. (07273/TC)
• Check the condition of the drive belt.
• Check the tension of the starter generator belt.
After the first 25 hours
• Change the engine oil (07266/TC).
After the first 50 hours
• Inspect opening on filter.
Before each use or daily
• Check the engine oil.
• Check the tire pressure.
• Check the transmission oil level.
• Check gear shift operation.
• Check the brake fluid level.
Every 50 hours
• Change the engine oil (07273/TC). (twice as often in special operating conditions;
refer to Maintaining the Vehicle under Special Operating Conditions)
• Check the battery cable connections for wear or damage.
• Check the battery electrolyte level.
Every 100 hours
• Grease the bearings and bushings.
• Inspect and clean the air filter element (twice as often in special operating conditions;
refer to Maintaining the Vehicle under Special Operating Conditions).
• Change the engine oil (07266/TC). (twice as often in special operating conditions;
refer to Maintaining the Vehicle under Special Operating Conditions)
• Change the oil filter (07273/TC). (twice as often in special operating conditions; refer
to Maintaining the Vehicle under Special Operating Conditions)
• Check the spark plug (07266/TC).
• Check the operation of the Neutral gear shift position.
• Inspect the condition and wear of the tires.
• Torque the wheel lug nuts to 45-65 ft-lb (61-88 N-m).
• Check the front wheel toe-in and front suspension.
• Clean the engine cooling areas (twice as often in special operating conditions; refer
to Maintaining the Vehicle under Special Operating Conditions).
• Inspect the brakes.
Every 200 hours
• Replace the air filter element.
• Inspect opening on filter.
• Check the parking brake operation.
• Check the condition and tension of the drive belt.
• Check the tension of the starter generator belt.
Every 400 hours
• Inspect the fuel lines and connections.
• Clean the primary drive clutch.
Every 800 hours
• Replace the spark plugs (07273/TC).
• Replace the fuel filter.
• Change the transaxle fluid.
Yearly
• Complete all yearly maintenance procedures specified in the Engine Operator’s
Manual.
Important:
Refer to your Engine Operator’s Manual for additional maintenance procedures.
21