Toro 03713, Руководство оператора

Страница: 22 / 24

Groomer Binding
Troubleshooting
1. Make sure the groomer is set to the desired height of
groom (HOG) (
Figure 44 ).
Figure 44
1. Quick-up lever (engaged
position) 3. Height adjuster knob
2. Groomer height (HOG) 4. Number of rear roller
spacers (below side plate
pad)
2. Loosen quick-up mounting bolt and make sure
threaded rod is in line and not binding on bottom
quick-up ramp (
Figure 45 ). Re-tighten bolts.
3. Check the length of the quick-up springs on the
threaded rods, the length should be 1-3/8 inch (3.5
cm) long (
Figure 45 ).
Figure 45
1. Quick-up mounting bolt 2. Height adjuster knob
4. If the height adjuster knob does not rotate freely, the
bushing may be dirty (
Figure 45 ). Clean the bushing
if necessary.
5. If a roller brush is installed, make sure the brush plate
(
Figure 46 ) is parallel to the cutting unit side plate and
is fully inserted into the rubber grommets.
G01 1430
1
Figure 46
1. Brush plate
6. Make sure the main drive bushing ( Figure 47 ) pivots
freely around the drive hub.
Figure 47
1. Main drive bushing
7. Make sure the shim ( Figure 48 ) between the drive side
groomer pivot plate and the cutting unit side plate is
not pinched by the pivot hub. Shim must be able to
move freely.
22