Toro 03698, Руководство оператора

Страница: 19 / 28

g020697
Figure 30
3. If end play exists, proceeded as follows:
A. Loosen the external setscrew securing the
bearing adjuster nut to bearing housing
located on the left side of the cutting unit
(
Figure 31 ).
g003332
Figure 31
1. Setscrew
2. Adjuster nut
B. Using a 1-3/8 inch socket wrench, slowly
tighten the reel-bearing adjustment nut until
no end play of the reel exists. If adjusting
the nut does not eliminate reel end play,
replace the reel bearings.
Note:
The reel bearings do not require
preload. Overtightening the reel-bearing
adjuster nut will damage the reel bearings.
4. Tighten the setscrew securing the bearing
adjuster nut to the bearing housing.
Note:
Torque the nut to 1.4 to 1.7 N∙m (12 to
15 in-lb).
19