Toro 03247, Руководство оператора

Страница: 33 / 52

33
Service Interval Chart
Caution
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition and disconnect the wire from the spark plug before you do any
maintenance. Set the wire aside so that it does not accidentally contact the spark plug.
Greasing the Bearings and
Bushings
The traction unit has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base Grease.
If the machine is operated under normal conditions,
lubricate bearings and bushings after every 50 hours of
operation. Bearings and bushings must be lubricated daily
when operating conditions are extremely dusty and dirty.
Dusty and dirty operating conditions could cause dirt to get
into the bearings and bushings, resulting in accelerated
wear.
The traction unit bearings and bushings that must be
lubricated are: steering column (Fig. 39), steering gears (2)
(under the skirt below the steering sector), steering shaft (2)
(Fig. 40), lift arms (3) (Fig. 41), pivot rods (3) (Fig. 42),
rear lift cylinder pivot (Fig. 43), traction pedal pivot
(Fig. 44) and rear wheel (2WD only) (Fig. 45)