Toro 03247, Руководство оператора

Страница: 14 / 52

14
Installing the Rear Wheel
Model 03422—Two Wheel Drive
Mount the wheel assembly to the rear castor fork with 2 flat
washers, axle, and locknut. Position the washers on the
outside of the fork (Fig. 1). Tighten the nut to 45–65 ft.-lb.
(3–5 N
⋅
m).
1
2
3
Figure 1
1. Wheel assembly
2. Rear castor fork
3. Axle
Model 03427—Three Wheel Drive
1. Mount the wheel assembly onto the rear wheel hub
(Fig. 2).
1
2
3
Figure 2
1. Wheel assembly
2. Rear wheel hub
3. Lug nut
2. Install the lug nuts (Fig. 2) and tighten them to 45–65
ft.-lb. (3–5 N
⋅
m).
Installing the Seat
The traction unit is shipped without the seat assembly.
Deluxe Seat Kit, Model 30797, or Standard Seat Kit, Model
30796, must be installed as follows:
1. Remove the shipping ties securing the lower seat slides
to the upper seat slides. Note the orientation of the
lower slides for correct reinstallation (Fig. 3).
1
2
3
Figure 3
1. Lower seat slide
2. Upper seat slide
3. Seat plate
2. Insert the lower slides onto the upper slides (Fig. 3).
3. On the Deluxe Seat, check the alignment of the
mounting holes with the seat plate. If the holes do not
align, remove the machine screws securing the upper
slides to the seat bottom. Move the seat slides inward to
the next set of mounting holes and secure them with the
machine screws and 4 locknuts (M8). Apply Loctite to
the fasteners.
4. Loosely secure slides to seat plate with fasteners
supplied with seat (Fig. 3).
Note: Mount the seat in the forward holes to attain forward
adjustment.
5. Tighten the flange nuts and check the operation of the
seat.