Toro 03240, Руководство по установке, Страница: 10 / 24

g346925
Figure 15
1. Shoulder bolt
3. Adjuster collar
2. Adjuster-arm rod 4. Idler assembly
5. Tighten the carriage bolts and locknuts securing
the HOC bracket assemblies to the side plates
(
Figure 16 ).
g346926
Figure 16
1. Adjusting bolt 4. Flange nut
2. Locknut 5. Cap screw
3. Carriage bolt and flange
locknut (3/8 with 5/8 inch
hex)
6. Tighten the locknut on the HOC adjuster bolt,
then back off the locknut 1/2 turn (
Figure 16 ).
7. Center the front roller between the HOC bracket
assemblies and lock it in place with the cap
screws and flange nuts (
Figure 16 ).
8
Installing the Groomer
Drive Cap
For Cutting Units without a Rear
Roller Brush Kit Only
Parts needed for this procedure:
3
Cap (for universal groomer assemblies with no rear
roller brush kit installed only)
Procedure
1. Clean the mounting area on the gearbox ( Figure
17 ).
g355416
Figure 17
1. Groomer drive cap 2. Mounting area
2. Apply a light coat of Loctite 609 retaining
compound (green) to the mounting area.
3. Install the groomer drive cap onto the mounting
area (
Figure 17 ).
10