Toro 02003-90001, Руководство оператора

Страница: 10 / 44

10
SETĆUP INSTRUCTIONS
4. Secure steering wheel with lockwasher and nut.
5. Tighten steering wheel nut to 37 N
.
m (50 ftĆlbs).
6. Snap logo cover into place.
INSTALL SEAT
(Fig. 6-7)
The Grounds Pro 2000-D is shipped without the seat
assembly. Standard Seat Kit, Model 30769 or Deluxe
Suspension Seat Kit, Model 02305 must be installed as
follows:
Seat Kit, Model No. 30769, Standard Seat:
1.
Mount a seat adapter plate to each seat spring with
(2) spacers, socket head screws and locknuts (Fig. 6).
2. Mount each seat adapter plate to bottom of seat
with (2) capscrews and washers. Position adapters
and springs as shown in figure 6.
3. Install seat switch into seat and secure electrical
connector.
4. Loosely mount front of seat springs to seat plate
with (2) capscrews and washers and rear with (2)
knobs and washers (Fig. 6).
Note: Mount seat in forward holes to attain forward
adjustment.
5. Slide seat to desired operating position and tighten
knobs.
6. Before starting machine, sit on set to activate seat
switch.
1. Adapter plate
2. Seat spring
Figure 6
1
2
3
4
3. Spacer
4. Seat plate
Seat Kit, Model No. 02305, Deluxe Suspension
Seat:
1.
Loosely mount seat slides to bottom of seat
suspension with (4) large spacers, (2) small spacers,
(4) carriage bolts and flange locknuts. Small spacers to
be positioned on top of rear large spacers. Seat slide
with fore and aft adjusting lever to be mounted on right
side of suspension. Over hanging lip of left seat slide to
be positioned inward.
2. Position threaded mounting studs of seat slides
into holes in seat mounting plate.
Note: Mount seat in forward holes to attain forward
adjustment.
3. Mount seat to seat suspension with (4) capscrews,
lockwashers and flatwashers.
4. Secure seat slide to seat mounting plate with (4)
locknuts.
Note: Seat plate may be removed from frame to ease
seat spring installation.
5. Plug seat switch wire connector into harness wire
connector.
Figure 7
1. Seat suspension
2. Seat slide
3. Large spacer
1
2
4. Small spacer
5. Adjusting handle (fore & aft)
6. Adjusting knob (operator weight)
3
4
5
6
6. To adjust seat for operator's comfort and weight
proceed as follows:
A. To adjust seat fore and aft, move handle, on
front of seat assembly, to the left. Release handle
to lock seat position.
B. To adjust for operator's weight, turn spring
tension knob; clockwise to increase tension,
counterclockwise to decrease spring tension.
INSTALL LIFT ARM KIT
(Fig. 8-15)
The Grounds Pro 2000-D is shipped without a lift arm
kit. Fixed Cutting Unit Lift Arm Kit, Model 02100 or
Floating Cutting Unit Lift Arm Kit, Model 02101 must be
installed as follows:
1. Slide lift arm kit A-frame onto traction unit
A-frame.
2. Secure A-frames together with locking pin and
hair pin cotter.