1.06 Routing the console cables
Dia 1 – The transmitter motherboard showing the master console connection sockets
(Inside the access door of the master console)
Each console has a grey cable coiled inside the console on the side nearest the master console. Each of
these has to be routed out of the console and into the master console. The cables should be supported
using 8mm cable clips every 30cm.
1. Open the coin acceptor door and locate the console cable.
2. Uncoil the cable and feed the plug out of the console using one of the large holes in the back or bottom
as required.
3. Route the cable to the master console and fit the plug into the correct numbered socket on the trans-
mitter motherboard (See Dia 1) (The socket numbers are on the transmitter motherboard cover). Do not
fix the cables in position at this time.
4. Repeat the routing for all console cables. It should be noted that the cable for the master console is
fitted at the factory. All of the console cables are the same length so some surplus will remain for consoles
close to the master console.
5. Leaving a small loop of cable in the master console, fix the cables in position starting at the master
console and working toward the standard console(s).
6. Coil up any excess cable and place it inside the standard console to one side, ensuring that the coil of
cable does not interfere with the operation of any of the console controls.
7. Repeat the cable fixing for any other consoles.
Note!
When you have finished connecting all of the supplied consoles check to ensure all of the master console
connection sockets have either a console connected or a dummy plug installed.
©Tornado International Ltd. 2019
-10-
Confidential
1N00-510 Genesis Boat User Manual v3 05/19
