7
• Ensure the machine is switched off before add-
ing or changing accessories.
Transporting the machine
CAUTION – Incorrect lifting techniques may
result in personal injury, where applicable do not
lift large and heavy machines without assistance.
We advise that the manual handling regulations
are followed.
Please refer to the technical table for details on
weight of machine.
When transporting the machine ensure that all
components, tanks and removable parts are
securely fastened, and that the supply cord and
plug are not trailing. Detach hose and wand from
machine where applicable.
Take extreme care when moving the machine up
or down steps or stairs.
Preparing for use
Electrical connection
Before connecting the machine to the power sup-
ply, check that your supply voltage corresponds
with that marked on the rating label.
The power supply cord plus any extension leads
should not exceed 100 ft. (30 m) in total, other-
wise you may experience problems starting up
the machine. The cross-section of any extension
cable wiring must be at least AWG 13 (2,5 mm²).
CAUTION - This machine is for indoor dry
use only and should not be used or stored
outdoors or in wet conditions.
CAUTION - If it is suspected that there is
hazardous dust or flammable materials
stop cleaning the area immediately and
consult your superior.
WARNING Only use accessories and
spare parts provided with the machine or
those approved by the manufacturer. The
use of other accessories may impair the
safety of the machine.
WARNING
WARNING - Before undertaking assembly
or changing of accessories/tools switch off
machine and unplug from the electricity
supply.
Should an extension cord be used, ensure cord
rating is adequate for the equipment. Do not use
extension cord in coiled condition as this could
result in overheating of the cord.
IMPORTANT - If the supply cord is dam-
aged, it must only be replaced by a special cord
available from the manufacturer or an authorised
service agent.
Symbols & Markings
How to assemble the vacuum
• Insert the hose into the socket on the front of
the vacuum cleaner (Fig 1).
• Twist in a clockwise direction until locked into
position.
Fig
1
Fitting the handle, wand and floor tool
• Fit the handle to the wand connection (Fig 2).
Fig
2
https://harrissupplyind.com - To Order Parts Call 608-268-8080
