Tormatic T 100 DES, Руководство по сборке и эксплуатации

Страница: 24 / 112

22 - EN T100 DES
13. Relay outputs
The control provides two potential-free change-over contacts
(250 V AC / 2 A, 24 V DC / 1 A).
The 24 V output at terminal X8 may be loaded with a maximum of
200 mA.
Select the desired relay function in menu items 45 and 46. If AR
operation (value 3 or 4) is selected in menu item 40, terminal X6
is assigned to the caution light function.
Fig.
a
Connection of an optical red-green signal encoder. Select
the value 0 in menu item 45 and the value 1 in menu item 46.
Fig.
b
Connection for the mutual locking of 2 doors (lock circuit).
Select the value 2 or 3 in menu item 50 and the value 0 in menu
item 45.
Fig.
c
Connection for the mutual locking of 3 doors (lock circuit).
Select the value 2 or 3 in menu item 50 and the value 0 in menu
items 45 and 46.
14. Light grid
As an alternative to the closing edge protection, a light grid can
be used. For this purpose, clamp the light grid as shown in
Fig.
a
or Fig.
b
. Set the value to 0 in menu item 35.
5 Programming
In order to program the Torsteuerung , open the housing cover.
The programming works in a menu-controlled fashion. Carry out
all settings as specified in the
Programming procedure chapter,
see also Representation of the menu structure . The Program
overview chapter shows the full scope of the menu.
Programming procedure
Proceed as follows to carry out programming settings:
1. Press the button to reach the programming of the con-
trol. The selection of the individual main menu (in the fol-
lowing referred to as "menu") appears on the LED display.
Up to 9 menus are provided.
2. Navigate with buttons to select the desired menu.
The LED display shows the current selection as value 1-9.
3. Confirm the selection with the button . The LED display
in the first digit now shows the menu which you are in. The
second digit shows the current menu item in this menu.
4. Navigate with buttons to select the desired menu
item. A total of up to 10 menu items is provided to you
(0-9). The LED display shows the current selection in the
second digit as value 0-9.
5. Confirm the selection with the button . The currently set
value for the respective menu item blinks on the LED dis-
play.
6. Set the desired value using the buttons . Depending
on the menu item, values between 0 and 99 can be
entered.
7. Confirm the entry with the button . The LED display
confirms the entry by 5-time blinking of the LED point and
by returning to the selection of the menu item.
8. If you want to complete the programming, press the but-
ton
repeatedly until – – appears on the display.
9. Confirm the selection with the button to exit the pro-
gramming.